Arcmage Box
Posted: Sat Jun 30, 2018 10:22
Hey folks,
I attempted to design a new box with the new arcmage logo.
As I wanted to keep the box rather small, I opted to have two boxes each containing
three preconstucted decks.
There are many things possible and I just choose a design with a lid and a box
- Rebirth lid I
- Rebirth lid II
- Rebirth box
DIY
1. Print the lid & box on A4
2. Put the sheets together so that the non printed sides are back to back and the printed sides are shown
3. Laminate them in a single A4 pouch (the front sides will be glued to the plastic)
4. Cut the borders of the pouch (you'll now have two sheets, laminated on one printed side)
5. Cut the lid and box on the light-gray cut-lines
6. Pre-fold the the box and the lid
7. Glue the lid and box together (tip, put glue on the inside of the side flaps first, then press the small folded flap),
Have fun!
Nico
I attempted to design a new box with the new arcmage logo.
As I wanted to keep the box rather small, I opted to have two boxes each containing
three preconstucted decks.
There are many things possible and I just choose a design with a lid and a box
- Rebirth lid I
- Rebirth lid II
- Rebirth box
DIY
1. Print the lid & box on A4
2. Put the sheets together so that the non printed sides are back to back and the printed sides are shown
3. Laminate them in a single A4 pouch (the front sides will be glued to the plastic)
4. Cut the borders of the pouch (you'll now have two sheets, laminated on one printed side)
5. Cut the lid and box on the light-gray cut-lines
6. Pre-fold the the box and the lid
7. Glue the lid and box together (tip, put glue on the inside of the side flaps first, then press the small folded flap),
Have fun!
Nico